0 Items 
View Our Customer Gallery

  Home > Automobile > Tail Light Covers >

VW Golf R (15-17) Smoked Tail Light Covers
VW Golf R (2015, 2016, 2017) Smoked Tail Light Film Covers

Price: $54.95

Installation Difficulty:
Includes: Both Sides, Instructions, Tools, 5-yr Warranty

Secure Shopping:     Made in USA: 

Ships: 2-3 business days
Part #: VW242S

Description FAQ
Lamin-x VW Golf R (2015, 2016, 2017) Smoked Tail Light Film Covers. These Smoked tail lamp covers is our medium-dark to smoke-out your rear lights. If you are searching for how to smoke-out my tail lights, then this high-quality overlay product is the perfect solution. The smoked film pigment is perfect for red or amber lenses while still allowing for great rearward lighting visibility.

Our products are made from high quality, adhesive-backed protective film that applies like an overlay directly onto the light. The films special adhesive allows for very forgiving installation. You can apply numerous times upon initial application to get it just right, and it can be easily removed in the future. Each kit is pre-cut to fit both the left and right tail lights.


Transparent film that adheres onto your tail light lenses

Glossy finish for high-quality look

Precut for both sides of your specific vehicle

Includes DIY tools and installation instructions

Made in USA, 5-year warranty, industry-leading product

VW Golf R (15- ) Tint Headlight Covers Car Door Edge Guards - Four 1/2" x 24" Strips VW Golf R (15- ) Gunsmoke Headlight Covers
Price: $59.95
Price: $9.95
Price: $59.95
VW Golf R (2015, 2016, 2017) Tint Headlight Films Covers Car Door Edge Guard VW Golf R (2015, 2016, 2017) Gunsmoke Headlight Films Covers

Average Customer Review: 1 of 5 Total Reviews: 1 Write a review.

  0 of 0 people found the following review helpful:
Absolutely Terrible August 16, 2015
Reviewer: Brandon from Westfield, IN United States  
The pre cut pieces are so exact that leave no room for working/manipulating on edges.  The small finger tabs are very hard to use and allow only a few touch points to keep finger prints off.  You would be better off only selling square sheets.  Obviously you are saving money on materials by sending such small cut pieces.  After following all of the instructions in your videos my light still did not allow for the product  to lay completely flat without puckering.  There are some shapes you should not be selling pre cut kits for due to the hard angles of the surface.  The only way you product might succeed on these taillights is if the vinyl was thinner, the piece was larger, and a pro installed it.  I called a shop to ask about if they would install them and they refused to work with lamin-x on rear lights due to the difficulty with the product.  This is a good shop that does tinting of all kinds.  The only easy part of this was peeling it off of my lights after I decided to give up.

Was this review helpful to you?